Multiple 1-wire sensors on same bus?

Suntherm
Posts: 11
Joined: Mon Feb 22, 2016 11:40 am

Multiple 1-wire sensors on same bus?

Postby Suntherm » Wed Mar 02, 2016 10:19 am

Hej team,

I'm building a small controller that will work with multiple 1-wire temperature sensors.
I've added a PLC channel in Mervis, and is able to find 4 of 4 sensors. But only able to attach one of them.
I thought that I just needed to repeat the process 4 times, but every time I select one sensor that's not matched yet, it replaces the one from before.
Image

Can you please give me some pointers on how to attach all my OneWire sensors?

thanks

Morten:)
Morten Veis Donnerup

SUNTHERM
Innovative heating and storage system
tomas_hora
Site Admin
Posts: 298
Joined: Wed Oct 29, 2014 9:56 am

Re: Multiple 1-wire sensors on same bus?

Postby tomas_hora » Wed Mar 02, 2016 10:33 am

Hello,

attach is used once you have the sensor added to the channel (also for replacing sensors).

If you want to add more sensors you can use two ways:
    automatic - Right click on 1Wire channel -> Detect One Wire Sensors and select what sensors you want to add
    manual - Right click on 1Wire channel -> Add library device -> UniPi -> OneWire -> 1W thermometer + than you need to attach the sensor as you did (or fill in the address, family, crc,... in the properties manually).

Remember, detecting/assigning new sensors must be made when the PLC is in COMMISIONING mode.

Return to “Mervis”

Who is online

Users browsing this forum: No registered users and 1 guest