24VDC BCD input signal

phlegx
Posts: 3
Joined: Mon May 02, 2016 3:50 pm

24VDC BCD input signal

Postby phlegx » Mon May 02, 2016 4:02 pm

Hi!
I have a BCD input signal with 24V on 4 input pins. How can I detect if a BCD signal has come (e.g. with evok)?
I don't have a UniPi board, because I want to check first if I can solve my problem to read BCD input signals.

Thx
tomas_hora
Site Admin
Posts: 298
Joined: Wed Oct 29, 2014 9:56 am

Re: 24VDC BCD input signal

Postby tomas_hora » Tue May 03, 2016 7:22 am

Hi,

I think it should be OK, but it also depends on your required sample rate..
phlegx
Posts: 3
Joined: Mon May 02, 2016 3:50 pm

Re: 24VDC BCD input signal

Postby phlegx » Tue Sep 13, 2016 1:36 pm

Hi tomas_hora!

Thank you :D. What do I need to wire my 24 VDC signal to the input? Which configuration I need to set on the UniPi? I have 24 VDC, the GND and the signal cable.

Another question: I cannot find any specification of the backup battery for the RTC module. Which battery should I buy?

Thx
tomas_hora
Site Admin
Posts: 298
Joined: Wed Oct 29, 2014 9:56 am

Re: 24VDC BCD input signal

Postby tomas_hora » Wed Sep 14, 2016 8:42 am

Hello,

see this: http://unipi.technology/wiki/Reading_si ... of_devices

The battery is CR2032
phlegx
Posts: 3
Joined: Mon May 02, 2016 3:50 pm

Re: 24VDC BCD input signal

Postby phlegx » Wed Sep 14, 2016 9:45 am

Thank you very much! :lol:

Return to “General discussion”

Who is online

Users browsing this forum: No registered users and 1 guest